|
Post by stumppuller on Aug 30, 2008 21:49:43 GMT -5
My new Jinma B/H would flex something awful while digging even though it was factory reinforced! I welded up a simple bracket which absolutely eliminates flexing. The first photo is the rectangular tube weldment. The other 2 show the bracket in place before drilling the final bolt holes which fasten to the 2 diamond plates. The top clevis for the 3-point hitch is connected with a hitch pin making it simple to remove.
|
|
|
Post by Ronmar on Aug 30, 2008 22:37:16 GMT -5
That is nice, I am working on something similar for my HW/YW-03 as it also flexes quite a bit in operation. I also found the base bolts where the hoe base connects to the subframe comming loose regularly on mine, most likley from the stress at that point. This type upper bracket should ease that considerably.
Ron
|
|